Written by Barkman Concrete Published on September 21st, 2021
BASIC FIRE FEATURES INSTALLATION NOTES FOR:
· Belvedere Fire Pit
· Dimensional Fire Pit
- Familiarize yourself with the construction details in this Technical Guide.
- Mark out the location for your fire pit. Note dimensions shown are nominal so mark an area slightly larger than shown.
- Excavate for drain stone base (approx. 6 in (152 mm))
- Fill excavated area with drain stone, level, and compact.
- Place and center steel ring on prepared base.
- Place blocks per the pattern. (For round kit, keep blocks 1 1/2 in (38 mm) off steel ring)
- WARNING! Do not place the fire pit directly atop a patio surface. Instead, the fire pit should be incut in to the patio surface to avoid damage to the patio caused by conductive heat transfer
ADDITIONAL STEPS ARE FOR ROUND FIRE PITS ONLY
- After placing blocks around the ring, adjust the blocks in or out to make the circle close and fit tight. If the blocks do not close the circle, move all blocks slightly in. If the blocks seem too long, move the blocks slightly out.
- Place caps in circle around fire pit. Adjust the caps in or out to make them fit tightly together
Note: Not suitable for large fires. Fire size should not allow flame to contact caps on round fire pit.
Note: Call your local dealer for more information on gas conversion in your area.
ROSETTA BELVEDERE FIRE PIT
FEATURES
· Featuring the look of weathered fieldstone
· Includes 52 wetcast concrete stones and a 14-gauge steel liner
NOTE: GAS INSERT
Talk to your local producer about gas insert options in your area
ROSETTA DIMENSIONAL FIRE PIT
FEATURES
· Featuring the texture of quarried stone
· Includes 36 wetcast concrete stones and a 12-gauge steel liner
NOTE: GAS INSERT
Talk to your local producer about gas insert options in your area
